Hi,

I have an Itron Ace6000 connected , I need to read the meter firmware version , I know that the obis code to get firmware version is 1.0.0.2.0.255 but it doesn't appears in the data tab of the meter in the program, Do you know how can I get the meter firmware version?

Thank You.

Hi,
I have a question, Can I set some meter date with DLMS Director?
Thank you.

Error reading.

Hi!

After installing version 8.0.0.5 can not read the answer Aare.
The parameters are the following:
-Media: Serial
-Client Address: 0x10
-Physical Server: 0x11
-Logical Server: 1

Hi!

I have a L+G meter and I can communicate with it perfectly without Authentication. But I want to read energy consumption and then I have to connect with Authentication. The manufacturer give me the reading key, that is 00000001.
The problem is when I write this key as Low or High Authentication because I receive the next message: Connection is permanently rejected. Authentication is required.

The parameters are the following:
-Media: Serial
-Client Address: 10
-Physical Server: 1
-Logical Server: 0

Hello I 'm trying to retrieve the time profile of the active energy injected and withdrawn . Among the Obis codes in the Director I was not able to try a find . I wanted to load other codes based on the SL7000 Manual . I went on the new button Obis I chose generic profile but the program does not allow me to upload my code. I can add their Obis by program or you can do it only you to code?
Thank you

Hello when I connect on Itron SL7000 I use seral 7N1 300 Baud DLMS , the first time using my parametetri but any subsequent connection starts a new connection at 9600 baud
8N1.Questo forces me every time that the connection runs in manually reset 300 7N1 . This counter works in IEC only 300 7N1 .
I wanted to suggest that it would be a good idea for SL 7000 or perhaps hammer for all counter starting in IEC and then pass in DLMS not change the connection parameters set in the profile .
I believe that the conditions to manage might be .

Hello,

I'm trying to read values of a SL7000 with Sync2000 but I failed.

My settings for Actaris(ITRON) SL7000:
- Start Protocol : DLMS
- Media : Serial RS485 Full duplex with 9600
- Authentication : Low
- Password : ABCDEFGH
- Client Address : 1
- Physical Server : 17
- Logical Server : 1
- Context application: LN
- HDLC addressing scheme : 4
- SL761xxxx

I'm trying to read a Landis+Gyr E450, it comes with a paper saying its DLMS firmware version is v5.22 and its reading key is 00000001. I downloaded the latest manufacturer info in GXDLMSDirector and just changed the authentication settings to low/high and setting the password as it is in the paper I got but I don't get any response from the meter.

I'm trying to read through optical port and the meter is from Spain in case this is relevant information.

Regards,

MA

Hi,

I have a problem, when I set Date of Landis E550 with .Map110 program, the program sends 6 frames, on the third, it sends 8 bytes before the FCS bytes, but I don't know from where they come, if someone Knows from where the 8 bytes come or how can I calculate it, let me know please , Here is the log of the program with the 8 bytes in red.

Thank You!

Hello I can not login on Itron SL7000 through local optical port.
I use IEC protocol, I realized that even if I set the connection to 300 Baud, and subject to the speed profile is automatically updated to 9600 baud.
You have any suggestions.
I am attaching the log of communication.
Thank you