IEC local port setup
This object configures the meter's local communication port, including its opening procedure, negotiated speed and local access passwords.
When to use it
Use it when setting up a local reading probe and checking the initial baud rate and meter address.
Attributes
1. Logical name
The OBIS code that identifies this object instance in the meter. Use it to distinguish this instance from other objects of the same class.
2. Default mode
Selects the protocol behavior used when communication starts on the port.
3. Default baud rate
Sets the communication rate used for the initial opening exchange.
4. Proposed baud rate
Sets the communication rate proposed by the meter for the session after the opening exchange.
5. Response time
Sets the minimum delay between receiving a request and beginning the response.
6. Device address
Holds the address used to select the meter during local communication.
7. Password 1
Holds the password for the local protocol's P1 password operation.
8. Password 2
Holds the password for the local protocol's P2 password operation.
9. Password 5
Holds the W5 password reserved for national applications.
Versions
Attribute availability depends on the object version reported by the meter (version 0: attributes 1-9; version 1: attributes 1-9). Use the version-specific descriptions above when an attribute's meaning or representation differs.
Actions
There are no actions available for this object type.