Hi, Mr Kurumi.
Thanks, as always, for your help. It's much appreciated.
Is it possible to read all the data from the meter without any user defined (read only)?
Best reagrds.

Respected Sir Kurumi.
Please, could you help me, I'm looking for password low authentication for Inhemeter DTZ1513. I try many password such as(00000000, 12345678, ABCDEFGH, ...) without success.
Best regards.

Hi, I can read the meter with no issues using the DLMSDirector, however does anyone know how i see the primary/sec ratio values from the L+G E650 meter?

0.4.2 gives me the CT ratio and 0.4.3 gives me the VT ratio but how do i read the numerator and denominator, for example 200/5 instead of seeing "40"

Hi, Kurumi. Please could you help me again.
I'm trying many settings to connect to EMH-XC SN4445110, but the meter still sending the same error: Failed to receive reply from the device in given time.
Thank you so mutch.
Media: Optical probe.

I am currently trying to read profiles. Since they can get very large, I read them row by row. However, when the reading process is complete, DLMSDirector shows only the first row that was sent by meter.

I observed that the meter correctly executes svr_getRequestNextDataBlock to get successive rows after the first one.

Hi,
Below error is showing when i am going to connect meter using MR association through optical port of meter.

serviceError Initiate Error exception. Initiate DlmsVersionTooLow

Hello,

when I open GXDLMSDirector I get this error:

'Could not find a part of the path'

After I close this window the software opens normally. So my question is if this error is important or can I dismiss it?

Thank you in advance

hello,
about gateway I have some problem.

how to set the gateway clientID and meter id when both of them use hdlc

if client use rs485 to gateway and gateway use rs485 to meter
client --HDLC-- gateway--HDLC--meter

1. client should send snrm to gateway,
2. gateway respone ua
3. client send gateWay protocol E6 xx AARQ
4, the gateway send snrm to meter or hdlc with aarq?

otherwise , gateway---meter clientId should be what?

Hello!

I would like to know what steps should be followed to have this software correctly installed and if it is necessary to download the DLMS libraries in GitHub beforehand for its correct development,

Thank you

Hi Kurumi,

First off, thank you for establishing and maintaining this forum!

I read data from my Kaifa MA309 / wired MBus interface using a raspberry / python script using your lib.
Reading the topics here in the forum I could confirm my findings, that 2 telegrams are sent each 5 ms cycle and that the data sent each cycle is 376 bytes.

Pasting the received data into GXDLMSDirector / Tools and translating however, it cannot not decrypt the encrypted message part - see pasted code below.