Hi,

Can i run wrapper protocol on serial port?

Thanks in advance

Hello ,
I am using Gurux Arduino server code on Arduino Mega. It seems that server code is at default none authentication. When I try to read from arduino server on Gurux DLMSdirector , it does read only association logical name as expected.
Now, I want to use server code at low authentication so that I can read other objects on DLMSdirector. I tried using low authentication as given in GuruxDLMSServerExample, but I am not even getting response of SNRM frame. I have put correct initial settings before connecting.

Hi,

I want to read linyang meter with low security do you have any default setting for the same.

Thanks,
Hajikhan

Thanks for your attention, We connect SL761X071 Meter through Serial port RS232, configured 9600 8N1None, with Initial Settings like File, please may you tell us how to access with write privilege?

Let's discuss GURUX tool installation and usage issues.....
Can anyone let me know how to write ToU (time of use).

According to Blue book following steps are required for image transfer.
1.Check if image transfer is enabled
2.Get image block size
3.Initiate image transfer (Individual or broadcast)
4.transfer image by blocks
5.verify completeness of image transfer

Hello,

For the COSEM Application tests in the GXDLMSDirector, can we know what these tests cases are?

However, testing my meters the COSEM Application tests failed, and I really can tell why? See log below

We are trying to use DLMSDirector to connect to Iskra MT383 with RS485 interface. The meter is connected to TCP/IP netowork through TCP/IP to serial gateway (comcontrol). We have been strugling with DLSMdirector settings. Based on research on this forum, we made the setting as per the attached image, however we have no luck connecting to the server.

We have read in the manual that the HDLC address is the last 2 digits of the meter serial number +16 thats why we have 42 as the physical address.

Any pointer on what could be wrong would be really appreciated.

Hello

I used the GXDLMSDirector Conformance Test scheme to check my dlms server, only 2 tests came back failed - Test 9 and Test 16.

I, however, tried to debug to see why this failed, and looking at the Log it appears that my responses were correct.

Hi,
I downloaded DLMSDirector and configured to connect with a Landis+Gyr meter.
On my side I have pc (windows 10) with usb/rs232 converter correctly working, Urmet GSM modem correctly working but trying to connect to the remote meter (static IP with SIM Card) the program reply
"Failed to receive answer from modem. Check serial port" or "Connection failed: no carrier (when telephone call was being establised). +CEER: 8,31,0".
what am I doing wrong?
Can you please guide me tosetting properly?
Thanks
Regards