While running confirmation test
/*****Test Report****/
Receiver Ready failed.
Test #1 failed.
Index was out of range. Must be non-negative and less than the size of the collection. Parameter name: index

HELLO SIR!! can you please provide me a solution my all conformance test is getting failed I tried more then 3 meters i'am getting same result please have a look at logs and provide me a solution to pass ma conformance test for meter

0.0.96.11.6.255 Event : Control value is not update in the GXDLMSdirector.

I would like to ask if someone have the default password and cipher key from Hexing HXE310 (M23 model)
The meter is brand new and it has the default settings from the factory, when I buy the meters (I have buy 3 of them) from the official Hexing dealer he didn't give any manual or other support document. Also the Hexing official factory support Center never respond to my emails.
If anyone can help me to make correct connection with that meter I will appreciate it.

Regards Lambros

iam testing a meter for conformance test iam gettint case failed for HDLC

I am trying to connect Holley DLMS meter with low authentication when i connect it after some time it gave me the error i think i get these while reading profiles or somting

(Gurux.DLMS.GXDLMSException: Access Error : Device reports Read-Write denied.)

After this when i try to read the data after a while on read it gave me this error.

(system.argumentoutofrangeexception: valid values are between 0 and 999, inclusive. parameter name: millisecond)

Both error logs are below :

Error 1 logs on connection :

While working with the meter I want to get information about invocation counter and server behavior.

1. What could be the behavior of server if we send the connection request in wrapper interface with different invocation counter value which server device have. Is server should respond with error or the communication continues?
2. Is there any condition when client is sending the request but server will not respond? ? If No is it mandatory that server should respond with some status code or success data?

Dear Mikko,

I want to read specific meter objects in one go.
Is it possible to read from GXDLMSDirector tool ?

It's possible in DLMSDirector convert octet value to readable string?

Thanks
Marco

hi, I have connected erp300 L&T dlms meter via serial com....But I got only manufacture's data and clock data only....I didn't got any data about voltage, current, kwh reading.etc.....i hope you will reply soon..screenshot is attached below...