I would like the invoke method 1, update_amount (data) in one of my credit objects. I can't figure out how to do this.
Do you support that service, and if no, do you intend to add support?
Thanks in advance, Martin

Hello,

If I change PaymentMode and/or Status values and try to write this attribute to meter, DLMSDirector send to meter old (not chaged) values.

regards,
Vitaly

Hello. My name is Evgen. I can't connect in Gurux GXDLMSDirector to ACE6000 via RS485 (after press "Connect" get "Fail to receiver reply from the device in given time"). For serial port i have 9600 8n1. I try with Authentication None and Low (with password ABCDEFGH) and get same connection error. In serial mort monitoring program i saw that data sent to ace6000 but nothing received from ace6000. Anybody can help me to solve this problem?

Hi ,

When we can use the option MQTT in media ?

BR ,

Hi Mikko ,

Can you please add Sanxing S12U16 in the manufacturer

Hi Mikko ,

we have a modem gprs integrated in meter , I would like to know number port is always 4059 or it depends on modem ?

sir
I want to read data from the ER300P energy meter using RJ11 port through arduino micro controller .
can you please help me with this how to go above ?

Hi mikko ,

We want to communicate with a CLOU meter via gprs modem ( @ip) , but it gives the error message :" no connection could be established because the target computer expressly refused it" , we tried with both IEC and DLMS .

we use the device properties below :

Hi,

I have pop up error when read ProfileGeneric object by all mode,

Thanks,
Mahsen.

Hi Mikko ,

There is no SerialNumber in options of Address type when using ELSTER Manufacturer .

BR,