Cannot set while record macro, it show message "object reference not set to an instance of an object". after stop record macro, it can set data normally. can you help to check this issue.

Guru director version 8.2.2010.0901

How is it possible that I can set the clock one hour back in time and NOT one hour forward?
Is it a setting in Gurux DLMS Director?

It concerns a EMH LZQJ-XC.

Dear sir
Please let me known how can i write /change the physical and logical address of energy power meter , i have access to SAP , but i can not see anything , in Access right tab that i see the SAP object is non - access .. if i change to acesss or read write but also can not read anything... pls help me
Thank you

I created a device list (.gxc extension) containing about 170 devices, each device has two object/attributes (1.8.0, 3.8.0).

All devices and objects/attributes are loaded successfully except for only one random device, the device is shown in device list but without any objects. Every time I reload the file I have different device with the same problem.

Regards

Hello Mikko,

I'm facing an issue while reading full association's data in GuruX software.
I'm testing meter according to "Indian standard" for "Meter Reader Association" and "Utility Specific Association". Connection is successful for both the associations, and interface classes are also reflecting correctly.
The detailed explanation for the issue is given below;

I am connecting to the Meter using "Serial over Ethernet", the connection is successfully done.

When I try to read for example the "1.0.1.8.0.255" register, DLMSDirector is sending and receiving without any problems, but I don't have any values.

When I repeat the "Read" process about three times, I receive "" then connect again to meter and "Read" again it I receive correct value !

Hi Gurux team!

We are using Gurux DIrector to trying read obis objects list from real meter using HighGMAC without general protection in conformance block.
We are able to see the 2 steps involved in the association in the Director log, but retrieving error from device in second step:
1. InitiateRequest (glo_InitiateRequest)
2. ActionRequest (GeneralGloCiphering) --> getting this exception response from meter

Hi Miko ,

I hope You feel great .

why I can't read and modify the objects , like this one below (IP setup) :

Hi ,

I want to connect with clou via a 3G modem , but i receive the error message bellow :

GXDLMSDirector 8.2.2009.0801
Log created 13:44:58
13:45:06 Initializing Network connection.
System.Net.Sockets.SocketException (0x80004005): Aucune connexion n’a pu être établie car l’ordinateur cible l’a expressément refusée
à GXDLMSDirector.GXDLMSDevice.InitializeConnection()
à GXDLMSDirector.MainForm.Connect(Object sender, GXAsyncWork work, Object[] parameters)

Thank You in advance .

Hi Mikko,

I am trying to connect to L&T ER300P meter through DLMSDirector. But my meter doesn't respond. I am certain it's due to some of my configuration. I tried Authorization mode None and Low with lnt1 password. But still no luck.

Could you please point me the mistake I am doing?

Thanks,
Abhiishek