Hello Mikko,

I'v got error window (one word only - "Index") while trying to view PushSetup.

A little bit investigation in source code shows that OnValueChanged and OnAccessRightsChange in GXDLMSPushSetupView.cs cycle through arg.Index from 2 to 4 only, throwin an exception for anything else.

At the same moment, data received from meter contains total 13 attribute index fields, as described in blue book 4.4.8.2 push setup class id 40, version 2 description.
So it seems Push setup IC description extended some time ago.

Hello Mikko,

I'm sorry for creating almost identical topic, it's because I'm unsure whether you are following all topic comments or new topics only.

The question is do you have some plans to implement UI ability to change permissions and weightings table values for Arbitrator class.

Best regards, Andrew

Hi
I have connected the meter RS485 to PC USB port via Rs485-USB convertor.

The virtual port is created by PC and it is listing.

But Director shows error "Device doesnot exists was specified"

Genus meter is connected and the same can be read thru Director thru Optical port.
Any help in this regard is appreciated

I need to connect smart meter with DLMS director,using rs485 protocol, so I am trying but its not working ,any link how to get data ,in public mode using rs485

Hi,
When I try to export a certificate from my meter, director send a message without signature. Same to remove. It is correct?
The ciphered context can be decrypted successfully by translator. Please help to check it. Thanks!

director version: 20241216.1
guek: 1111111111111111
gak: 2222222222222222
client title: CTT00000
server title: Vango321
security suite: suite 1
security policy: authentication&encryption

Hi,

I am very new to this forum and I hope you can help me.

I try to read data from landis+gyr ZMD405CR44 using USB to optical eye with DLMSDirector. But I don't know how to setup parameter that can make me to read with it.

Please give to some guide on how to do it.

Thank you beforehand

Facing issue with gx director 9.0.2412.1801 RTC format differ than my PC RTC.

Hi I am working on Secure 300 Premier Energy Meter, I am using RS232 to TTL Converter. I have the following questionaries below

As per this forum https://www.gurux.fi/node/21057

1. Do we need to short the 4,6 pins as well as the 7&8 pins in DB9 Connector.
2. If yes, these pins are not connected to RJ11 connector, what is the reason of shorting these pins?
3. In RS232 Trans receiver IC, Can I use T2out and R2in pins as CTS and RTS pins and can i pull up these pins with external resistor ?

Hi Mr. Kurumi , I want to connect with SHA1 authentication level to my Hexing meter. The GXDLMS Director don't support that function in the Authentication menu (only none, low, high) for that manufacturer .
How can I add that function manually or how can I connect with SHA1 authentication level when I try to connect with my meter?? Is possible to do that?? Please support me.

regards Lambros

Hello, i'm trying to connect with a Wasion meter in GXDLMSDirector, i finally got access to the official software with Wasion, i tried putting the same keys/authentication, etc, but when i try to read the same register i read in the official software, GXDLMS returns "Exception response. "Service not allowed"-exception. Operation not possible".