Currently, I am working on communication with the A1800 meter, at this moment I can connect with a low authentication and enable the DLMS /COSEM protocol in the respective meter using other software (Metercat). The problem appears when I try to interrogate a specific day or another interval of dates related to the generic profile, but the only result I have received is the following: "Access error: the device informs read-write denied.

Good Morning;

I'm trying to access data from a ZIV counter with DLM-Cosem procolo, there's no way to get it. I always get communication error ...
Can it be some kind of password? The probe if it blinks ...

Hi kurumi,

I am facing an issue in writing time to Landis Gyr E650 meter using high authentication.
The meter is in Indian standard,
client address: 48(x30)
logical server: 1
Authentication: HIGH
I have checked the password with the manufacturer and I am using the right one.

NOTE: I am able to read all values and to write transformer ratio.

Clock object is having Read/Write access but its showing- "Access Error:Other reason." while I am trying to write time from the application.

Dear Sir,
I am facing an issue with reading profile generic values as they are not giving values multiplied with scalars.
Gurux application is reading values multiplied with scalar. for eg: voltage 11281*.01=112.81
same while I am trying to read from my code its not showing multiplied values but giving value just as 11281.
Eg: L&G E650
"1.0.94.91.0.255Ch. 0 Identifiers for India" same is having an obis code "1.0.94.91.3.255Ch. 0 Identifiers for India" with scalar and unit.

Hi,

I am running "GuruxDLMSServerExample" as a server and DLMSDirector as a client for reading data.
I am able to read clock object from that server but unable to read register object from that server.

I have connect DLMSDirector to "GuruxDLMSServerExample" with "None" authentication.

I am fetching below mentioned register object-
Ch. 0 Sum Li Active power+ (QI+QIV) Inst. value
1.0.1.7.0.255

When we want to get value credit object (0.0.19.10.0.255) from meter, we got message "Specified cast is not valid". Pls help us to solve this problem.

Can we use same code for monitoring multiple parameters of multiple dlms meters. How Gurux directory supports in this.

How can i set up EMH meter by EMH Metering GmbH? It always say that "failed to get reply from the device"..i am using com port...what should i do?

I have used Gurux GXDLMSDirection version 8.1.1807. My meter used Texas Instrument DLMS library.

We have some question about authentication security and transport security that supported by GXDLMSDirector.

1. Is the GXDLMSDirector support authentication algorithm AES-128 (mechanism_id = 2) ?
if it supported, please give us the settings of GXDLMSDirector to run the authentication algorithm

hi,
i'm reading the registers of some Iton SL7000 761 Ref. Firmware 5.35 using ACEPILOT software using GSM modem.
i would like to try to do it also with GXDLMSDirector 8.0.1703.1301 using GSM modem (by terminal).
please, can you give me info about the default initial settings?
moreover:
- the firmware version must be set in any place? in ACE pilot software it is required!
- the meter Serial number must be set in any place? in ACE pilot software it is required!
i hope to receive a feedback!
best regards Claudio Liciotti