HI. I have tried to take the values for the 1.0.9.6.0.255 and 1.0.10.6.0.255 under register. This communication in done using high authentication. But cannot obtain the result. While other required parameters such as energy can obtain.

thanks

Hi,
I new to this forum. So if miss something please correct me.

I have a secure premier 300 meter which supports DLMS protocol. I am trying to connect with meter using USB to RS232 cable. But I am getting no response.

The meter serial number is X1714625

The connection details is attached.

I think there's a bug in the GXDLMSDirector when reading the Scaler value in Register Object:
With the same meter the GXDLMSDirector shows Scaler value 1 and through dotNet code it shows Scaler value 100 (this is correct value for this meter).

Hi, I'm using DLMSdirector to try to read out (initially at least) from a Data Protection Object (Class_ID = 30). but the object does not seem to appear in the object list, and the IC does not appear in the tree view - I do get "Error - device reports an undefined object".
I'm wondering if anyone has had success in reading a Data Protection Object?

Thanks!

Hello,

I got some errors when I was trying to read the DLMS meter with "GXDLMSDirector".

Please suggest solutions.

Hi, Mr Kurumi.
Thanks, as always, for your help. It's much appreciated.
Is it possible to read all the data from the meter without any user defined (read only)?
Best reagrds.

Respected Sir Kurumi.
Please, could you help me, I'm looking for password low authentication for Inhemeter DTZ1513. I try many password such as(00000000, 12345678, ABCDEFGH, ...) without success.
Best regards.

Hi, I can read the meter with no issues using the DLMSDirector, however does anyone know how i see the primary/sec ratio values from the L+G E650 meter?

0.4.2 gives me the CT ratio and 0.4.3 gives me the VT ratio but how do i read the numerator and denominator, for example 200/5 instead of seeing "40"

Hi, Kurumi. Please could you help me again.
I'm trying many settings to connect to EMH-XC SN4445110, but the meter still sending the same error: Failed to receive reply from the device in given time.
Thank you so mutch.
Media: Optical probe.

I am currently trying to read profiles. Since they can get very large, I read them row by row. However, when the reading process is complete, DLMSDirector shows only the first row that was sent by meter.

I observed that the meter correctly executes svr_getRequestNextDataBlock to get successive rows after the first one.