Hello Mikko,

I have become a real fan of your software, unfortunately I keep running into problems, so here's a question again:

When trying to read a profile no data appears. There are 10 entries, which I can read out without problems using .MAP110 (software from Landis+Gyr). In the Director this usually does not work. Sometimes data appears but most of the time it does not. Do you have any idea what the problem is?

BR,
Manuel

Hi Mikko,
I am using GuruX director v8.2.2111.1801. I have made a setup to to periodically pull data from 5 meters over 4G TCP wrapper. I sometimes observed that communication is failing because of additional garbage bytes appended at the beginning of the frame. I tried probing meter to see if meter is sending these garbage values but didnt find any garbage outputting from meter. Your view on understanding the problem would help solve the issue.

Also one more observation when it happens is, part of previous response bytes gets appended to subsequent responses.

Please I am working on a Clou meter, CL730D21L. Could you please help with the communication interface properties of the RS485 i.e. baud rate, parity, stop bits, etc; Low and HighGMAC Authentication passwords and client address in each case. I intend to use the details to connect to the meter using DLMSDirector. Thanks

Hi all,

since the last update of the GXDMLSDirector (15.11.2021) I get the following error message when connecting:

LLC bytes are missing from the message.

The version before the update, as well as Old Gurux DLMS Director for .Net 3.5 worked fine with the same setting.

Is there anything I need to do with the new version?

Thanks for your help!

Best regards,
Manuel

Hello,

I have the following problem, I have like 10 HolleyMetering Meters connected to a DCU and I want to read there data, I have their password and all meters supposed to have the same configuration.
I have disconnected a meter from the daisy chain loop and tried to connect to it using RS485 and GuruxDirector. I have been able to read the meter successfully using the provided password, but when i try to read another meter it wont read even though they have the same configuration (I disconnected the other meter from the loop to try and read it as the first one).

Hello, Mikko

Can you explain, why do you use "100001" bit string as value for "protocol version" field of AARQ in conformance testing ?
Conformance test APPL_OPEN_4 check for DLMS protocol version support.
DLMS Green Book assumes the only Version1 (0) have to be supported.
In my understanding it means verification for bit string "1" for "protocol version" field.
But you use "100001" bit string.
Why ?

Regards
Vitaly

Hello,

I'm trying to read several Holley meters.

I have succeeded in reading a single meter using serial communication, but when I connect all meters in daisy chain loop then try to read them I get a getobject failed error.

I'm kind of new to this world, Any help in this?

Trying to connect to AS3500 meter, but no luck. Does someone ha ve instruction for last version of GDLMSDirector?

Serial Port monitor doesn't work. When i press open, i can't connect to my device. So this function just losing it's purpose.

Hi,
I´m trying to read meter ME383 with Iskraemeco default configuration through serial port but I´m getting "Failed to receive reply from the device in given time." message from GuruxDirector.(9600 8N1).

I tried with HDLCwithModeE and optical probe, with same result:"Failed to receive reply from the device in given time."Bitrate 300, 7E1.