when I read the L1 Voltage in the GXDLMS Director, I wonder 2 times the read command packet was observed in Log File.

Please mention the Comments below mention read command and Response from the Device.

Note: In the Director, I was sent 1 time to Read the L1 Voltage.

pending data byte description

hi sir iam unable to read data in gurux dlms director for L&T EM101+ meter
settings are 9600 none 8 bit one stop bit
authentication Low, password: lnt1
16:47:18 Initializing serial connection.
16:47:19 Send SNRM request.
7E A0 07 03 23 93 BF 32 7E
16:47:19
7F BF 7E A0 1E 23 03 73 7B CF 81 80 12 05 01 80 06 01 80 07 04 00 00 00 01 08 04 00 00 00 01 53 3B 7E
16:47:19 Parsing UA reply succeeded.
16:47:19 Send AARQ request.

Hi sir,
iam trying to read L&T EM101+ meter data using DLMS director.
but iam unable to read data. iam getting error as failed in diconnect mode.
settings are client address is 0x11
authentication: Low
password: lnt1

on meter it is printed as compatible with IS 15959 CAT C3

this is my log

In the GXDLMS DIRECTOR Energy and Instantaneous Parameter Details missing.
In the Client Id used:16 ( General Association Id )

The NIK meter is not in the list of manufacturers, is it possible to add it yourself manually?

https://nik.net.ua/en/category/metering-devices

I attach the logs of the native program and Gurux:

230213 11:07:48:256 Information: "Port is opened"
230213 11:07:48:263 Mode E
230213 11:07:48:272 --> 2F|3F|21|0D|0A|
230213 11:07:49:623 <-- 2F|4E|49|4B|35|5C|32|4E|49|4B|32|33|30|37|20|76|32|2E|30|30|2E|0D|0A|
/NIK5\2NIK2307 v2.00.

I have a CEWE Prometer 100 meter which I am trying to read data from using GXDLMSDirector. I can access the meter successfully using level 1 access (LLS). However, I am unable to access the meter at level 2 (HLS).

HDLC Address Resolver Serial Settings do not apply

hi sir,
iam trying to read saral secure meter through gurux dlms director.
i used low level authentication with password ABCD0001.
Iam getting FRAME IS NOT FULLY RECEIVED.

hi Kurumi, i hope you are doing well.
it's been a while that i get from the vendor all securities parameters in order to connect in HLS GMAC to the meter and trying to get data from the meter. but i keep struggling to establish this connection by using GXDLMS with the suitable application context that i get from the communication between the meter vendor software and the meter.
i want to understand why the connection keep faikling, and your help to set the right application context for this.