Hi,

I am trying to communicate with Secure Saral meter using Gurux client library . Interface used is Serial.

Mikro Usb on Meter to Db9. Parameters i used are following:

a) Server Address : 3
b) Client Address : 32
c) Password : ABCD0001
d) Type of Addressing : Logical
e) Logical Server : 1
f) Authentication Type : Low

Tried with different possible combinations but no success.

i need connect DTZ27 to Gurux ?

Hello,

My modem has a small CPU. It consumes a lot of time to process parseObject in GXDLMSReader.
I found the AssociationView has been stored when I use -o option and I wonder how can I use this output file to skip parseObject process in the next run.

Is it possible to do that? Please share the solution.

Many thanks in advance.

Hello
We have elster A1800 Alpha Model A1830RALN s150 with 1xRS485 and 1xRS232
Serial Number ZE3NR4CR1LM-61
3x220/380, 50 Hz. There are name plate show that dlms COSEM compliant.
In the past, when install meter with metercat. Meter ID was s serial number.
However we do not have metercat software and information of meter.

how to read data end send request. DTZY217 i need reed parameters

i need DTZY217 wire smart meters parameters. help me ?
DLMS / cosem compliant support .

address : 21
obis code : 21.11.1
serial port: com6

I'm a real newbie with Serial port communication.
The documentation have for the serial device says I must send this:
1.1.1 Get Status
Get Status Command Format
Byte(s) Value
0-1 0x8001
Response: Immediately after receipt of this command the IDEC will transmit the Status report
message described in the previous IDEC responses section.

Hello,

I am used Sumeru verde energy meter(ERP300P).
I am used Gurux.DLMS.Python to read the value of energy meter.
My energy meter is high level password and its password is 2222222222222222.
I am run the command python main.py -S /dev/ttyUSB0 -a High -P 2222222222222222 -c 48.
Its given a errors...

Mikko,

I am developing Test application in which data will be read from meter via the serial interface.

Using Gurux.Serial we got the proper frame (means 7E to 7E )on the receive event.

But, If I am trying to read without Gurux. Serial in that case how to identify that start and end of the frame on the serial interface.

Can you please provide an update.

Greetings,

I am not able to get the server address.
I didn't understand this page
https://www.gurux.fi/dlmsAddress

can you please help me out to covert this on
553 and it's none Auth with the 0x16

Hi Mikko,

Currently we are using Director to read data from meter. And from logs we can check that "7E" receives in the data. So can you please help us to understand how does DLMS come to know about frame completion?

Thanks