Hello,

I am reading the obis 0.0.96.50.50 and when I change the value and try to do the write operation, a popup 'Invalid cast from 'System.String' to 'Gurux.DLMS.GXBitString' appears. I have never experienced this earlier. Can you please help me with this.

Thanks and Regards

Hello,

I have recorded a macro and would like to run it multiple times. The goal is to test the stability of the communications with the meter.

Is it possible to automatically run the same macro N times ?

Best regards,

Nelson Gonçalves

hi, i'm new in metering and DLMS protocol
please can we export values of the meter to an Excel Sheet with the DLMSDirector, if yes, please tell
thanks you for your help

hello, i have tried Gurux with holley ddsd285 and some other types and still facing the same errors when trying to edit access to read or write, kindly check the images below.
and also when requesting a reset process for a value i'm getting : Access error : Device reports a hardware fault with the yellow caution of : Device reports a undefined object.

everything else is working fine, but i still can't write even when connecting in low authentication mode with 00000000 as pwd.

i'm using a serial connection, please advise.

Hi,

The time/date value shown on all pages is adjusted to timezone/local time of the laptop/pc on which we are using Gurux. But, if the meter is in different time zone & laptop/pc is in different time zone, then it creates confusion as the date/time recorded in meters memory & date/time shown on gurux pages does not match.

Is there any option available to show the time/date value as it is, without considering the timezone of laptop/pc ?

Thanks & Regards,

Anil Bhide

Hi,

We tried to read the meter with default settings, but its refuse the connection, we tried with client address 0x1, 0x10, 0x11, 0x12 but the result is the same

Hi Guru,

1) Is it possible for Gurux Director to read from Gurux Android server? as per my understanding, Arduino server can act as meter simulator.

Gurux director seem keep getting timeout, even with correct COM port and 9600 baud rate. I suspect Arduino server didn't reply, it may due to wrong parameters value.

2) Do you mind to share the new Devicde Properties parameters value? Or anything I miss out? Such as:

Manufacturer : Gurux
Client address : 16
Logical address : 0
Physical address : 1
Media : Serial

Hi,

I am trying to change the ESWF(Event Status Word Filter) which has got Bit-String Data Type, but getting error(attached image) even when i change any bit in edit window and write write operation seems deactivated even when meter has provided read-write access to respective attribute.

Please suggest where we could be wrong.

Thanks in Advance

Hi,

I could not able to write an attribute of Limiter Class which was even given read-write access, please have a look at the attached images.

Please suggest where we could be wrong.

Thanks in Advance

Hello,

Whenever I read any object I get an error 'ServiceError Read exception. Service Unsupported'

This is happening in HLS, LLS

What might be the problem ?

Thanks