Hi,

Do Director listen on IPV6 on TCP and UDP ?
Do Director supports Receiving Large Push Data Notification using GBT?

Thanks in advance !!!

Hi,

With latest version of Gurux director 8.2.2008.2701; Association with HighGMAC is not connecting for HDLC over local port it gives exception "service not allowed", with older version it is working fine.

With Regards,
Ritesh NAIK

Hi Mikko,

I am trying to write Passive Relay Time (1.0.96.128.30.255) into IS15959-2 meter.

In that, If I change any value of structure and try to write, I got an error message as shown in the attached image. Please check.

Following is the response from meter:

<Structure>
<UInt32 Value="500" />
<UInt32 Value="900" />
<UInt8 Value="4" />
<OctetString Value="FF FF FF FF FF FF FF FF FF FF FF FF" />
</Structure>

Hi Mikko,

HLS is not working with the latest version of Gurux director 8.2.2008.2701.
With the same project file, we can connect with an older version 8.1.2006.2302.

We are facing this issue with HDLC over a serial port.

Kindly let me know if you need more information.

Thanks & Regards,
Chintan Patel

Hi Mikko,

I am trying to decode the frame from using DLMSTranslator from GXDLMSDirector.

In that, I have configured all secured details in Ciphering. Still not able to decode a secured HDLC frame from that.

Can you please provide a suggestion on how to decode frame using Translator

I am trying to read data from Landis+Gyr E150 meter using the DLMS director software. But one thing, I noticed was that for L+G meter, OBIS codes were not present and the same for some other meters as well.
Has anyone noticed this?

Hi Sir,

Getting Exception (ServiceError Initiate Error exception. Initiate IncompatibleConformance) in GXDLMSDirector while reading DLMS Smart meter as per Indian standard, which is following the IS15959 part 2 DLMS standard.

Below is the reading configuration.

Manufacturer: Indian Standard
Start Protocol: DLMS
Physical server: 1
Logical server:0
client Address:20
Interface: HDLC
Address Type: Default
Logical Name Referencing: true
Authentication: Low

Hello.

I'm trying to read load profile values "ProfileGeneric" from my EMH LZQJ-XC meter.
All attempts will result in an error message.

Translated from German:
"The offset must be between plus and minus 14 hours.
Parameter name: offset"
Attachement: '1.0.99.x.x_offset error_GuruX8.jpg' and '1.0.99.x.x_offset error message_GuruX8.jpg'
Program version: 8.2.2007.0602

Hi Mikko,

I am testing IS15959-2 meter.

Currently, I am reading invocation counter in public mode and then connect meter in HLS.

So, If we want to read RTC then the following requests will be sent to the meter.
- SNRM, AARQ, Read Invocation Counter, Disconnect
- SNRM, AARQ, High Association, Read RTC, Disconnect.

To read only RTC from meter we need to send a total of 9 requests to the meter.

So, can we optimize (Without reading invocation counter) the number of requests sent to the meter?

HOW TO GET the physical server from ID meter ?

for example : what is the physical server of ID meter =35074728

Thanks