Good Evening sir

I am facing issue while firmware upgrade in smart meter through gurux as during image transfer it shows the hard fault error , i am attaching the log for your consideration.

Hello. I would like to ask for your support. I am trying to read a meter from a Chinese brand. When making the connection without access level I can obtain the Type parameters AssociationLogicName and Data. But, when I try to login with the password using the values ​​show in the image (example, -h 192.168.1.1 -p 4001 -c 32 -s 32767 -a Low -P ******* -w 1 -f 128 -t Verbose ), I get an error from the GXDIRECTOR application.

I very much appreciate your collaboration.

The frame generate is:

Hi, Mikko,

I read IP6 Setup from an Indian Standard meter.

I found out about the GXDLMSDirector from a reference in this document.

- https://www.netz-noe.at/Download-(1)/Smart-Meter/218_9_SmartMeter_Custo…

However, my L&G E450 Smart Meter comes from "STW Klagenfurt"

- https://www.energieklagenfurt.at/stromnetz/smart-meter/

In this case, the documentation for the Mbus interface is not as detailed as for EVN Netz.

Hi, Mikko,

I'm trying to interface with an Indian standard meter.

Hi I am connecting to and interfacing with Kamstrup Omnipower electricity meters. Using the module port association on the Gurux dlms director, I use the following settings:
Client Address=18
Physical Address=16
HDLC with max transmit and receive size to 1010
The connection is Serial at 9600 baud rate
The authentication is Low with password 12345.

I have tried to decrypt my encrypted smart meter data with this version 9.0.2404.1801. To do this, I copied the encrypted message (which I also copied to the Serial Monitor) to Messages in the DLMS Translator and entered my Global Unicast Encryption Key (GUEK) under Ciphering. When I click on File-> Translate, however, nothing happens - on the right-hand side I only see the block cipher key and no decrypted data. Smart Meter is the Sagemcom T210-D-r from Energienetze Steiermark.
Does anyone have any idea what is going wrong here?

KR
Franz

Hi, Mikko,

I've searched almost all the forum topics regarding "pre-established" AA, but didn't find the similar situation I'm meeting.

I tried indian standard of PUSH association which needs this pre-established AA.

In secured connections, I ticked "pre-established system" and set the HEX value of 8 bytes of server system title.

I input the value of invocation counter which I had read by public Client, I'm sure the invocation counter is more than the actual value.

But I got the following log:

I am connecting to a Kamstrup OMNIPOWER CT meter. Director connects successfully but when downloading the object list, there are no Register or ProfileGeneric values available to read.

If I use the Kamstrup MeterTool application, I can connect and view the Analysis logs.

I am not using a username or password on either application.

I am assuming that this is a configuration or user policy issue. Can someone point me in the right direction to solve this problem.

Hello. I tried to connect to the counter and got this error. What could be the problem?