By amyst, 7 October, 2020 Forums DLMSDirector Hi Mikko, I am trying to connect to L&T ER300P meter through DLMSDirector. But my meter doesn't respond. I am certain it's due to some of my configuration. I tried Authorization mode None and Low with lnt1 password. But still no luck. Could you please point me the mistake I am doing? Thanks, Abhiishek Image Hi, Hi, Are you using an optical probe or RS-232/RS/485? BR, Mikko I am using RS485 port. I have I am using RS485 port. I have RS485 to USB serial converter using that I have connected to meter. Thanks, Abhiishek Hi, Hi, Check your cables. The reason is usually in cables or then the baud rate is wrong. Tryo to change the baud rate. BR, Mikko Log in or register to post comments
I am using RS485 port. I have I am using RS485 port. I have RS485 to USB serial converter using that I have connected to meter. Thanks, Abhiishek
Hi, Hi, Check your cables. The reason is usually in cables or then the baud rate is wrong. Tryo to change the baud rate. BR, Mikko
Hi,
Hi,
Are you using an optical probe or RS-232/RS/485?
BR,
Mikko
I am using RS485 port. I have
I am using RS485 port. I have RS485 to USB serial converter using that I have connected to meter.
Thanks,
Abhiishek
Hi,
Hi,
Check your cables. The reason is usually in cables or then the baud rate is wrong. Tryo to change the baud rate.
BR,
Mikko