I created a device list (.gxc extension) containing about 170 devices, each device has two object/attributes (1.8.0, 3.8.0).

All devices and objects/attributes are loaded successfully except for only one random device, the device is shown in device list but without any objects. Every time I reload the file I have different device with the same problem.

Regards

Hello Mikko,

I'm facing an issue while reading full association's data in GuruX software.
I'm testing meter according to "Indian standard" for "Meter Reader Association" and "Utility Specific Association". Connection is successful for both the associations, and interface classes are also reflecting correctly.
The detailed explanation for the issue is given below;

I am connecting to the Meter using "Serial over Ethernet", the connection is successfully done.

When I try to read for example the "1.0.1.8.0.255" register, DLMSDirector is sending and receiving without any problems, but I don't have any values.

When I repeat the "Read" process about three times, I receive "" then connect again to meter and "Read" again it I receive correct value !

Hi Gurux team!

We are using Gurux DIrector to trying read obis objects list from real meter using HighGMAC without general protection in conformance block.
We are able to see the 2 steps involved in the association in the Director log, but retrieving error from device in second step:
1. InitiateRequest (glo_InitiateRequest)
2. ActionRequest (GeneralGloCiphering) --> getting this exception response from meter

Hi Miko ,

I hope You feel great .

why I can't read and modify the objects , like this one below (IP setup) :

Hi ,

I want to connect with clou via a 3G modem , but i receive the error message bellow :

GXDLMSDirector 8.2.2009.0801
Log created 13:44:58
13:45:06 Initializing Network connection.
System.Net.Sockets.SocketException (0x80004005): Aucune connexion n’a pu être établie car l’ordinateur cible l’a expressément refusée
à GXDLMSDirector.GXDLMSDevice.InitializeConnection()
à GXDLMSDirector.MainForm.Connect(Object sender, GXAsyncWork work, Object[] parameters)

Thank You in advance .

Hi Mikko,

I am trying to connect to L&T ER300P meter through DLMSDirector. But my meter doesn't respond. I am certain it's due to some of my configuration. I tried Authorization mode None and Low with lnt1 password. But still no luck.

Could you please point me the mistake I am doing?

Thanks,
Abhiishek

I would like the invoke method 1, update_amount (data) in one of my credit objects. I can't figure out how to do this.
Do you support that service, and if no, do you intend to add support?
Thanks in advance, Martin

Hello,

If I change PaymentMode and/or Status values and try to write this attribute to meter, DLMSDirector send to meter old (not chaged) values.

regards,
Vitaly

Hello. My name is Evgen. I can't connect in Gurux GXDLMSDirector to ACE6000 via RS485 (after press "Connect" get "Fail to receiver reply from the device in given time"). For serial port i have 9600 8n1. I try with Authentication None and Low (with password ABCDEFGH) and get same connection error. In serial mort monitoring program i saw that data sent to ace6000 but nothing received from ace6000. Anybody can help me to solve this problem?