Hi
I am trying to get data from Holley DTSD545S 3-phase smart meter using Lora mesh wireless transmitter. To get data I used RS-485 and Gurux GXDLMSDirector. Unfortunately, I can't get data and don't know how it works. Should i use other software to get data? Do you have any advice?

Name : ER300P
Manufacturer: Larsen & Toubro Ltd
Interface : HDLC
Authentication : LOW
Password: lnt1
Client address : 0x11
Logical Sever: 0
Physical Server: 1 and 22 both are used.
media : serial
baudrate: 9600.(8N1)

With this GXDLMSDirector settings. meter doesn't respond to AARQ request.
SNRM>UA is ok. Need any change in settings ? please reply as soon as possible

Hello. It is possible to add the option to select a number (address) а Logical server? According to the logs, addresses are scanned from logical address 0, but the energymeter can work as a logical device with address 1, etc.

Hi,
I have a problem with reading energymeter Star DTS27 via GXDLMSDirector. Below are my settings:
- Interface: HDLC
- Authentication: Low
- Password: 12345678
- Wait time: 00:00:05
- Address Type: Default
- Logical Server: 0
- Media: Net
- Client address: 2
- Resend count: 3
- Physical server: 1

- Host name: 10.249.79.4
- Port: 4004
- Protocol: TCP

When trying to connect, an error appears:
ServiceError Initiate Error exception. Initiate other.

Communication logs:

Hi,

During HDLC Test #1 in the conformance test, the client sends a Receiver Ready frame with SenderFrame = 0x10, but the meter does not respond. The test fails with “Receiver Ready failed.”

I'm using the following code:

Hi,

I already shared a message about that. Still not found solution. And also I tried Landis+Gyr E550 meter.

Dear Sir,
This code for modified tod time error not coming but in meter not updated.
Encription & authentication key=bbbbbbbbbbbbbbbb
HLS=BBBB1234BBBB1234

Hello Sir, We are currently using Gurux Director software to test a meter and have observed an issue with how the serial number is displayed in the Security Setup section, specifically below the "Server System Title" box. It appears that the serial number shown is derived only from the last three octets of the Server System Title, instead of the expected five octets. For example, the Server System Title hex stream is: 4B 5A 4B 00 05 0A 2F 7D (This corresponds to "KZK + 84553597")

I am able to use the simulator without a physical meter by configuring the 'Serial' media with 'localhost'. Is it also possible to use the simulator over the 'Net' media using the same local IP address to simulate communication as with 'localhost'?

I Downloaded the latest DLMSDirector, connect and read Association is OK. But the resault is not include the "Wi-SUN setup (class_id = 95, version 0)", In fact, the data frame contains this data item. Some data frames are intercepted as follows: