I use Mode E protocal.
In physical.req/ind Stage, I finish handshark and enter HDLC Stage.
When I receive SNRM command, and I return RA Command.
But director show "System.IO.IOException: 裝置無法辨識命令。"

how do I trace the client.GetData(p.Reply, reply)) function to find my bug?

I use director to verify Mode E.

my device properties as att. file,
(start protocal : IEC / name : pro / manufacturer : iskraemeco / serial mode )

when i press connect, director will be sent /?! by uart_tx.

my meter sent "/pro2isk000654321" to director, but director will be stop and show " B0 " and " Failed to receive reply device "

I dont know some thing wrong. can i read more detial error message?

Hi

I have some strange problem,
I need to read registry 1.8 and 2.8 on demand and profile where is storage data of this registry 1.0.99.1.0.255

when I read registry I have values like this:
1.8
7,75314797773613E+17
-3,09988391851445E+17
-2,66753835428689E+17
-1,51461684968004E+17
-2,89637751035265E+16
8,63565228548293E+16
2,08854432719307E+17
3,31352342583784E+17
4,46644493044469E+17
5,69142402908946E+17
6,91640312773424E+17

Hi,

Can I read an Elgama EMS meter using protocol IEC 62056 ?
Because I am trying to connect with DLMSDirector but it does not work.
Do you have any solution for that?
Thank you very much!

Hi,

I have an Itron Ace6000 connected , I need to read the meter firmware version , I know that the obis code to get firmware version is 1.0.0.2.0.255 but it doesn't appears in the data tab of the meter in the program, Do you know how can I get the meter firmware version?

Thank You.

Hi,
I have a question, Can I set some meter date with DLMS Director?
Thank you.

Error reading.

Hi!

After installing version 8.0.0.5 can not read the answer Aare.
The parameters are the following:
-Media: Serial
-Client Address: 0x10
-Physical Server: 0x11
-Logical Server: 1

Hi!

I have a L+G meter and I can communicate with it perfectly without Authentication. But I want to read energy consumption and then I have to connect with Authentication. The manufacturer give me the reading key, that is 00000001.
The problem is when I write this key as Low or High Authentication because I receive the next message: Connection is permanently rejected. Authentication is required.

The parameters are the following:
-Media: Serial
-Client Address: 10
-Physical Server: 1
-Logical Server: 0

Hello I 'm trying to retrieve the time profile of the active energy injected and withdrawn . Among the Obis codes in the Director I was not able to try a find . I wanted to load other codes based on the SL7000 Manual . I went on the new button Obis I chose generic profile but the program does not allow me to upload my code. I can add their Obis by program or you can do it only you to code?
Thank you

Hello when I connect on Itron SL7000 I use seral 7N1 300 Baud DLMS , the first time using my parametetri but any subsequent connection starts a new connection at 9600 baud
8N1.Questo forces me every time that the connection runs in manually reset 300 7N1 . This counter works in IEC only 300 7N1 .
I wanted to suggest that it would be a good idea for SL 7000 or perhaps hammer for all counter starting in IEC and then pass in DLMS not change the connection parameters set in the profile .
I believe that the conditions to manage might be .