My custom meter is calculating the active power in kW but in the DLMS Blue book only W (enum 27) is defined. The requirement for us is to send the active power in kW only. How do I do that and make the units as kW?
I am adding DLMS compatibility over serial port to my custom single phase electricity meter and I needed some help in figuring out which OBIS codes would be appropriate for my use case. Here is my use case.
I measure the following meter parameters from the metering chip every 15 seconds and put them in an array:
1. Current RMS
2. Voltage RMS
3. Frequency
4. Wide band power
5. Fundamental power
6. Reactive power
7. Wide band energy
8. Fundamental energy
9. Reactive energy
10. Phase angle
I'm investigating your solution for reading data from the meters in Portugal. The software we will use to read data from the meters only support javascript library. Do you have any libraries that we can use in our software ?
I want to import the certificate in meter with action with block transfer method but gurux always requested with segmentation i.e 0xA8 event if meter negotiate conformance with action with block transfer.
