Before commenting read Forum rules
Don't comment the topic if you have a new question.
You can create a new topic selecting correct category from Gurux Forum and then create a new topic selecting "New Topic" from the top left.
Forums
Hello,
I have the following problem, I have like 10 HolleyMetering Meters connected to a DCU and I want to read there data, I have their password and all meters supposed to have the same configuration.
I have disconnected a meter from the daisy chain loop and tried to connect to it using RS485 and GuruxDirector. I have been able to read the meter successfully using the provided password, but when i try to read another meter it wont read even though they have the same configuration (I disconnected the other meter from the loop to try and read it as the first one).
** please note that all meters wont read except for the one i tried on first.
What could be the problem?
Moreover if i want to read directly from the DCU, What is the address I need to use? and is it possible?
Kind Regards,
Hi,
Hi,
I have answered this question in here:
https://www.gurux.fi/node/19341
Please, don't post duplicate questions.
BR,
Mikko