Meter Setup

Forum Rules

Before commenting read Forum rules

Don't comment the topic if you have a new question.

You can create a new topic selecting correct category from Gurux Forum and then create a new topic selecting "New Topic" from the top left.

By ikhwan5313 , 16 November, 2018
Forums
DLMSDirector

How can i set up EMH meter by EMH Metering GmbH? It always say that "failed to get reply from the device"..i am using com port...what should i do?

Kurumi

7 years 6 months ago

Hi,

Have you selected EMH Metering GmbH as a manufacturer? It might be that the baud rate is wrong.
Try to change that. Check also your cable.

BR,

Mikko

ikhwan5313

7 years 6 months ago

I have selected EMH Metering GmbH as manufacturer. Do cable failures may be the cause of unable to communicate?

ikhwan5313

7 years 6 months ago

For your information, i am using EMH NXT4 meter by EMH metering GmbH

Kurumi

7 years 6 months ago

Hi,

In 80% cable failure is the reason why communication is not working. If you are using USB converter,
don't use any other converter between a PC and the meter. It's quite common that there is a USB2RS232 converter and then RS232 is connected to the optical head. The power level is often too low for optical head in cases like this and it doesn't work.

BR,

Mikko