OBIS codes for use case

Forum Rules

Before commenting read Forum rules

Don't comment the topic if you have a new question.

You can create a new topic selecting correct category from Gurux Forum and then create a new topic selecting "New Topic" from the top left.

By bhatiasidharth.89 , 19 October, 2021
Forums
General discussion

Hi Mikko,

I am adding DLMS compatibility over serial port to my custom single phase electricity meter and I needed some help in figuring out which OBIS codes would be appropriate for my use case. Here is my use case.

I measure the following meter parameters from the metering chip every 15 seconds and put them in an array:
1. Current RMS
2. Voltage RMS
3. Frequency
4. Wide band power
5. Fundamental power
6. Reactive power
7. Wide band energy
8. Fundamental energy
9. Reactive energy
10. Phase angle

After every 15 minutes I send these array values to my server (not using DLMS for TCP connectivity).

What OBIS codes should I use to represent these register values for reading over serial port?

Thanks
Sidharth

bhatiasidharth.89

4 years 11 months ago

Hi Mikko,

Awaiting your reply on this please.

Regards
Sidharth

Kurumi

4 years 11 months ago

Hi Sidharth,

You need to read your association view example with GXDLMSDirector. Then you will know what OBIS codes your meter manufacturer is using. It looks like your meter is using Indian Standard and those OBIS codes are described on the IS 15959 Part 2 documentation.

BR,
Mikko