DLMS with Arduino IDE

Forum Rules

Before commenting read Forum rules

Don't comment the topic if you have a new question.

You can create a new topic selecting correct category from Gurux Forum and then create a new topic selecting "New Topic" from the top left.

By ichsan05 , 22 March, 2022
Forums
Gurux.DLMS

Hello,

I have question regarding the DLMS.c master for Arduino IDE

1. Is there any documentation for the code what to be and not to be defined in the code or there's a setting to use serial port RS-232 because i need to connect my MCU to The smart meter using RS-232
2. Is it safe to directly connect MCU to RX TX GND of smart meter?

Thank you in advance.

Kurumi

4 years 6 months ago

Hello,

1. You can start from here: https://www.gurux.fi/Arduino
The Arduino example is already using RS-232.

2. You need to check that your UART power levels are the same on the MCU and the meter.

BR,
Mikko

ichsan05

4 years 6 months ago

Thank you so much for the reply i will immediately try it

Regards,
Ichsan