Hlo sir ,

When i am parsing and decrypt the data of received push data then i got some exception i.e., invalid data type and invalid command . How i can resolved this issues . I am attaching some pictures for your refrence.
I need your response urgently .

hi mikko,
1)I have an example where i need to connect the server first in association 0.0.40.0.0.255, then after disconnect request, i need to connect it back to other association ex 0.0.40.0.1.255 then again after 5 min when rx comes as disconnect, i need to connect back to 0.0.40..0.0.255, is this possible to change association in between the requests?

Hi,
I'm trying to make server with multiple association objects and specify different set of objects to each association. It is possible to create it in that way? My first test ended up with Hardware fault and now I'm getting all the objects.

Hi,
I am trying to write the Limiter Normal Threshold parameter through Gurux Java library. Getting below exception.

gurux.dlms.GXDLMSException: Access Error : Device reports a unmatched type.

Below is my code,
GXDLMSLimiter lm = new GXDLMSLimiter("0.0.17.0.0.255");
lm.setThresholdNormal(18720);
com.writeObject(lm, 4);

Other parameter I am able to write. Only facing problem with Threshold Normal.
Gurux DLMSdirecter also its working.

Kindly help me to resolve this issue.

Sir, I am new to this smart meter project can u help me how to establish the connection with the meter using static IP. My meter make is Genus. Shall i need to configure anything in the meter or just inserting the SIM into the meter is sufficient please help me i struck at this point.

1)in GXDLMSAssociationLogicalName.class we have logical name as "0.0.40.0.0.255" can we change this another association??
2)if we want to provide key then can we use setKek for giving the key??

Hi!

Getting the address field
Through the following procedure
Calculate the serverAddress as ‘0x1163E’ to get ‘00 08 58 7D’
But this is actually wrong,
What is right should be:00 02 58 7D

Hi,
I was downloading association from meter and when I tried to load it back (using GXDLMSObjectCollection.load and save) I got XMLStreamException.

Hi,
I am doing firmware upgrade in Java.
How do I clear the transfer buffer to be sure that it's empty before I start my transfer?
Thank you

hi Mikko,
I see that in DLMS Server code whenever the client sends data onReceived function is called, in my case client will send data until display is ON, so till then rx, tx is working fine, then later i am closing the program from the stop operation in Intellij instead I want to close server, so i wrote close(); function inside onreceived() function, but sevrer got closed after the first RX only, is there a way to stop server after client stops sending data?